Phil Duffy
Articles
-
HOW TO: Set up your DC charger to a LAN network
Step 1: Check the LAN Cable ConnectionMake sure the charger is physically connected to your network:The LAN cable must be plugged into the internal network portIt should click securely into the m...
-
HOW TO: Set up your DC charger to a LAN network
Step 1: Check the LAN Cable ConnectionMake sure the charger is physically connected to your network:The LAN cable must be plugged into the internal network portIt should click securely into the m...
-
HOW TO: Change the DC output (kw) on your DC charger
Follow these steps to adjust the maximum charging power of your DC charger.Step 2: Open Protection SettingsOn the charger screen:Tap ManagementSelect Protection ParametersStep 3: Enter the Password...
-
HOW TO: Connect your DC charger to a 4G network
Set Up 4G Connectivity on Your ChargerFollow these steps to connect your charger to the 4G network.Step 1: Check if the 4G Kit is InstalledBefore starting, confirm that the 4G kit is installed in t...
-
PE Fault
PE refers to the earth potential of the cable. CausesNormally this faut would occur when an earth connection has become loose or faulty, either with the installation or within the charger itself. R...
-
How to retrospectively fit a 4G kit within your charger (Installer Only)
In this guide... We'll explain how to fit a 4G kit into your your Project EV Charger. Use our step by step guide below: For Laptop Setup, follow steps 1-15 of How to commission your charger usin...
-
How to commission your charger using a laptop
In this guide... We'll show you how to set up your laptop to configure the Project EV Charger.Please see the video below: Prefer written instructions? Use our step by step guide below if you ...
-
My Project EV charger is not working and there are no lights on the unit
Frequently Asked Question... My Project EV charger is not working and there are no lights on the unit Answer: Check that the circuit breaker at the consumer unit is in the on position. If the ...
-
My Project EV app is showing my charger as “Preparing”
Frequently Asked Question... My Project EV app is showing my charger as “Preparing” Answer: Press “Start” on the app or use RFID card to start a charging session. If the charger does not start...
-
How to commission your charger using a laptop
In this guide... We'll show you how to set up your laptop to configure the Project EV Charger.Please see the video below: Prefer written instructions? Use our step by step guide below if you ...